Previous  Up

Rubber Plugs on Timing Gear Cover


  • 2. Ensure that the dowel pins are firmly seated.
  • 3. Place one rubber plug on each end of the counter pressure oil line and install in the timing gear cover so that the open end of the upper plug faces the crankcase while the open end of the lower plug is inside the timing gear cover (see Fig. 154).
  • 4. Inspect oil seal at crankshaft pulley and replace if worn or damaged.
  • 5. Use new gasket under generator carrier.
  • 6. Torque retaining nuts of timing gear cover to 2 mkp (14. 5 lbs/ft).
Last modified: Mon, 17 Jan 2005


Site Details. Disclaimer. Comments? Questions? Dave Hillman
Content attribted to others remains their property. Otherwise the text and images are licensed under a Creative Commons License.
Creative Commons License Valid XHTML 1.0 Transitional Valid CSS!