Previous  Up  Next

Ready to Reassemble the Pedal Cluster


  • All bearing surfaces have been cleaned with wire brush and sand paper.
  • 6 of the bushings from the kit are clearly visible.
  • The busing for the clevis pin has been pressed into the actuating arm on the right side of the picture.
  • Not shown is the roll pin included in the kit.
  • Visible on the top of the brake outer tube is a zirk fitting for adding more grease. I added this fitting.
Last modified: Thu, 28 Dec 2000


Site Details. Disclaimer. Comments? Questions? Dave Hillman
Content attribted to others remains their property. Otherwise the text and images are licensed under a Creative Commons License.
Creative Commons License Valid XHTML 1.0 Transitional Valid CSS!