Previous  Up  Next

Heater Gate Valve after Adjustment


  • Fully off position. The control lever is as far from the cable end as possible.
  • I turned the lever upside down from the factory position because it seemed to match the position of the cable guide better.
  • The lever is clamped to the gate valve shaft by the compression of the bolt. There is a flexible washer between the lever and the gate valve housing.
  • The gate valve is spring loaded to the open position as shown. It is not apparent how to replace this spring if required.
  • The red color is from rust inhibiting primer.
  • Again, sorry for the out of focus picture.
Last modified: Sun, 13 Jan 2002


Site Details. Disclaimer. Comments? Questions? Dave Hillman
Content attribted to others remains their property. Otherwise the text and images are licensed under a Creative Commons License.
Creative Commons License Valid XHTML 1.0 Transitional Valid CSS!